Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura ZDXFACTORY OEM SERVICE PROCEDURE
Front Passenger's Power Window Switch Replacement
- Remove the front passenger's power window switch panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Remove the four screws (A), then remove the front passenger's power window switch (B) from the power window switch panel assembly (C).
- Install the switch in the reverse order or removal.
- After replacement, reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.