2012 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Transmission Reassembly

Special Tools Required 

Mainshaft Holder Set 07PAB-0010001

NOTE:
  • Refer to the EXPLODED VIEW  in the Transmission Disassembly as needed during the following procedure.
  • Apply a light coat of clean ATF on all tubes, O-rings, and moving parts before reassembly.
  1. Make sure that the ATF magnet (A) is cleaned and installed in the torque converter housing. Clean and install the ATF magnet, if necessary.
    Fig 1: ATF Magnet, Main Separator Plate, Dowel Pins And ATF Pump Driven Gear With Torque Specifications
    G08066821Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.