2012 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Total Starting Torque Measurement

NOTE: To prevent damage to the transfer housing, always use wood blocks or equivalent materials between the transfer housing and a bench vice.
  1. Remove the transfer assembly (see TRANSFER ASSEMBLY REMOVAL  ).
  2. Secure the transfer housing (A) in a bench vise (B) with wood blocks.
    Fig 1: Identifying Transfer Housing, Bench Vise, Companion Flange, Torque Wrench And Socket
    G08066894Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Rotate the companion flange several turns to seat the tapered roller bearings.
  4. Measure the total starting torque at the companion flange (C) with a torque wrench (D) and a socket (E).

    Standard: 2.64 - 4.23 N.m (26.9 - 43.1 kgf.cm, 23.3 - 37.4 lbf.in) 

  5. If the total starting torque is out of the standard, replace the transfer assembly.

Fluid Leak Check 

  1. Check for fluid leaks between the mating faces of the transfer assembly and the transmission.
  2. If there is leak, remove the transfer cover, then replace the transfer cover oil seal and the O-ring (see TRANSFER COVER OIL SEAL REPLACEMENT  ).
  3. Check for fluid leaks between the transfer companion flange and the transfer oil seal.
  4. If there is leak, replace the transfer oil seal and the O-ring (see TRANSFER COVER OIL SEAL REPLACEMENT  ). Do not replace the oil seal with the transfer assembly on the transmission.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.