Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

With SH-AWD

NOTE: Before you work on the fuel lines and fittings, read the Fuel Line/Quick-Connect Fitting Precautions .

If equipped, remove the quick-connect fitting cover from the fuel line. Raise the cover (A) from the fuel line (B), and remove it as shown.

Fig 1: Removing Quick-Connect Fitting Cover From Fuel Line (With SH-AWD)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Relieve the fuel pressure .
Check the fuel quick-connect fittings (A) for dirt, and clean them if needed.

Fig 2: Identifying Fuel Quick-Connect Fittings - With SH-AWD (1 Of 3)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.