Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Rear Window Replacement
NOTE:
- Wear eye protection while cutting the glass adhesive with a piano wire.
- Put on gloves to protect your hands.
- Use seat covers to avoid damaging any surfaces.
- Do not damage the rear window defogger grid lines, the window antenna grid lines, or the terminals.
- Remove these items:
- Trunk lid
- Rear door opening seal, as needed (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
- Rear center seat belt lower anchor (see REAR CENTER SEAT BELT AND REAR SEAT BELT BUCKLES )
- Rear window molding (see REAR WINDOW MOLDING REPLACEMENT )
- Disconnect the window antenna connectors (A) and the rear window defogger terminals (B).
- If the original rear window will be reinstalled, make alignment marks across the rear window and the body with a grease pencil.
- Pull down the rear area of the headliner (A) by detaching the clips.NOTE: Take care not to bend the headliner excessively, or you may crease or break it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.