Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2012TL BASEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEMNAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION
2012 Acura TL Base
Navigation Display Unit Removal/Installation
2012 Acura TL BaseSECTION Navigation Display Unit Removal/Installation
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
- When prying components, use the handy remover set or equivalent.
- Remove the dashboard center vent (see DASHBOARD CENTER VENT REMOVAL/INSTALLATION ).
- Remove the screws and bolt (A) from the navigation display unit (B).
- Pull out the navigation display unit. Then disconnect the connector (A) from the navigation display unit.
- Install the navigation display unit in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.