Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Without Keyless Access System
2012 Acura TL BaseSECTION Without Keyless Access System
NOTE:
- Air temperature must be within 59- 100°F (15- 38°C) during this procedure.
- After the inspection, you must reset the PCM. Otherwise, the PCM will continue to stop the fuel injectors from operating.
- The battery must be in good condition and fully charged.
- Remove the engine compartment covers (see ENGINE COMPARTMENT COVER REPLACEMENT ).
- Connect the alternator, regulator, battery, and starter tester (OTC3131) to the battery as shown.NOTE: The probe is not used for battery testing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.