2012 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

System Description: Notes

This system consists of the battery sensor, the gauge control module, the driver's MICU, the passenger's MICU, the alternator, and the ECM/PCM.

The battery sensor measures the battery current, voltage, and temperature in all ignition switch positions. This data is used to control the alternator output, the idle speed, and the interior lights. These are the advantages of this system:

  • Helps to prevent over-discharge of the battery.
  • Helps to protect engine cranking amps.
  • Helps to extend the battery life.
  • Helps to improve fuel economy.
  • Helps to alert the client of the battery condition.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.