Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Audio-Navigation Switch Panel
- The navigation hard buttons and interface dial are used to input commands.
- The display mode button switches the display between Day mode, Night mode, and off.NOTE: When you activate this button, the navigation auto dimming is turned off until you turn the ignition switch to LOCK (0) or press the engine start/stop button to select OFF mode.
- The audio button displays the audio system information.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.