Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura RLFACTORY OEM SERVICE PROCEDURE
Shift Lever Installation
- Install the shift lever bracket (A) on the shift lever bracket base (B) with the four bolts (C).
- Install the shift lever assembly by aligning the positioning holes (D) with the tips (E) on the console panel.
- Loosely install the mounting bolt (F) on the left front of the shift lever, then install and tighten the mounting bolt (G) on the left rear to 22 N.m (2.2 kgf.m, 16 lbf.ft).
- Install and tighten the mounting bolts (H) on the right side, then tighten the left front bolt to 22 N.m (2.2 kgf.m, 16 lbf.ft).
- Connect the shift lock solenoid connector (I), park pin switch/A/T gear position indicator panel light connector (J), and the yaw rate-acceleration sensor connector (K).
- Install the harness clamps (L) on the shift lever bracket.
- Install the shift cable on the shift lever bracket, and adjust the shift cable (see step 7 ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.