Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura RLFACTORY OEM SERVICE PROCEDURE
Power Windows DTCS
POWER WINDOWS DTC DESCRIPTIONS
| DTC | Description |
|---|---|
| DTC B1132 | Left Rear Power Window Motor A-Phase Pulse Signal Input Error |
| DTC B1133 | Left Rear Power Window Motor B-Phase Pulse Signal Input Error |
| DTC B1134 | Right Rear Power Window Motor A-Phase Pulse Signal Input Error |
| DTC B1135 | Right Rear Power Window Motor B-Phase Pulse Signal Input Error |
| DTC B1136 | Internal Right Rear Power Window Sub Switch Malfunction |
| DTC B1148 | Internal Left Rear Power Window Sub Switch Malfunction |
| DTC B1147 | Left Rear Window Position Data Error |
| DTC B1149 | Right Rear Window Position Data Error |
| DTC B2175 | Driver's Power Window Motor A-Phase Pulse Signal Input Error |
| DTC B2176 | Driver's Power Window Motor B-Phase Pulse Signal Input Error |
| DTC B2177 | Assistant's Power Window Motor A-Phase Pulse Signal Input Error |
| DTC B2178 | Assistant's Power Window Motor B-Phase Pulse Signal Input Error |
| DTC B2187 | UART Communication Error1 (Driver's MPCS Unit From DR Door ECU) |
| DTC B2188 | UART Communication Error2 (Driver's MPCS Unit From Other Node) |
| DTC B2189 | Driver's Window Position Data Error |
| DTC B2190 | Assistant's Window Position Data Error |
| DTC B2191 | Assistant Door ECU Internal Error (EEPROM Error) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.