Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura MDXFACTORY OEM SERVICE PROCEDURE
Rear Power Window Switch Test/Replacement
- Remove the rear door panel (see FRONT DOOR SIDE SILL SEAL REPLACEMENT ), and disconnect the 14P connector from the rear power window switch.
- Remove the power window switch panel (see FRONT DOOR SIDE SILL SEAL REPLACEMENT ).
- Remove the three mounting screws and the rear power window switch (A).
- Swap the rear power window switch with another known-good power window switch and test. If the original power window switch is faulty; replace it.
- Install the switch in the reverse order of removal.
- Reset the power window control unit
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.