Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Acura MDX V6-3.7LFACTORY OEM SERVICE PROCEDURE
Cruise Control Module: Service and Repair
Adaptive Cruise Control (ACC) Unit Removal/Installation
1. Remove the glove box Service and Repair.
2. Remove the stereo amplifier Service and Repair.
3. Remove the bolts from the bracket that hold the ACC unit (A).
4. Disconnect the connector from the ACC unit.
5. Remove the ACC unit from the bracket.
6. Install the unit in the reverse order of removal.
NOTE: If a new ACC unit is installed, do these operations:
- Do the ACC unit update procedure Testing and Inspection.
- Do the CMBS initial check (DTC100) 100.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
