2012 Acura MDX V6-3.7LFACTORY OEM SERVICE PROCEDURE

Cruise Control Combination Switch Test/Replacement




Cruise Control Combination Switch Test/Replacement

SRS components located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair, in the SRS before doing repairs or service.

1. Remove the driver's airbag Driver's Airbag Replacement.

2. Remove the cable reel subharness 20P connector.

Factory service manual diagram





3. Check for continuity between the terminals in each cruise control combination switch position according to the table:

- If there is continuity, and it matches the table, but the cruise control combination switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the cruise control combination switch Overhaul.

Factory service manual diagram




4. Install the parts in the reverse order of removal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.