2012 Acura MDX V6-3.7LFACTORY OEM SERVICE PROCEDURE

Programming and Relearning




Keyless Entry Transmitter Programming

1. Have the immobilizer PCM code from the iN system.

2. Connect the HDS to the data link connector.

3. Turn the ignition switch to ON (II).

4. Select IMMOBI from SYSTEM SELECTION MENU, then select the IMMOBILIZER SETUP menu.

5. Select Keyless Transmitter Registration.

6. Do the registration according to the instruction of HDS screen.

7. Turn the ignition switch to LOCK (0) and remove the key. Wait 10 seconds and verify that all remotes being programmed are functioning properly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.