Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2011 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Multi-information Display Indication Pattern

WARNING: This page is about a different car, the 2010 Acura TL and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Some examples of indication patterns are shown.

When the door is opened and the power mode is OFF, the display alternates every 3 seconds.

Fig 1: Multi-Information Display Indication Pattern (Door Opened And Power Mode OFF)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

When the power mode is ACC, the display alternates in 3 seconds.

Fig 2: Multi-Information Display Indication Pattern (Power Mode ACC)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

When the power mode is ON.

Fig 3: Multi-Information Display Indication Pattern (Power Mode ON)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.