Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Signal Circuit Troubleshooting
- Start the engine
- Turn the blower switch on
- Turn the A/C switch on
- Check the A/C CLUTCH in the DATA LIST with the HDS
Does it indicate ON?
YES -Go to step 5
NO -Check the A/C system (see A/C SYSTEM INSPECTION )
- Check the A/C system operation
Does the A/C system operate?
YES -The air conditioning system circuit is OK
NO -Go to step 6
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Activate the A/C CLUTCH in the INSPECTION MENU with the HDS
Is there a clicking noise from the A/C compressor clutch?
YES -Do the A/C system test (see A/C SYSTEM TEST )
NO -Go to step 9
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
- Jump the SCS line with the HDS
- Disconnect PCM connector A (49P)
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Momentarily connect PCM connector terminal A13 to body ground with a jumper wire several times
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there a clicking noise from the A/C compressor clutch?
YES -Update the PCM if it does not have the latest software (see ECM/PCM UPDATE ), or substitute a known-good PCM (see SUBSTITUTING THE ECM/PCM ), then recheck If the symptom/indication goes away with a known-good PCM, replace the original PCM (see ECM/PCM REPLACEMENT )
NO -Check for poor connections or loose terminals at the A/C clutch relay and the PCM If the connections are OK, check the A/C clutch relay (see POWER RELAY TEST ) If needed, repair open in the wire between the PCM (A13), the A/C clutch relay, and the other A/C system parts
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.