Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Fuel Fill Pipe Removal/Installation
- Dram the fuel tank (see FUEL TANK DRAINING )
- Remove the left rear wheel
- Remove the fuel fill pipe cover (A)
- Disconnect the fuel fill tube
- Without SH-AWD Disconnect the quick-connect fitting (A), and disconnect the fuel fill tube (B) from the fuel fill pipe by sliding back the clamp On the fuel fill tube, then twist the hose as you pull to avoid damaging the hose or pipe
- With SH-AWD Disconnect the quick-connect fittings (A) (see WITH SH-AWD )
Without SH-AWD
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With SH-AWD
- Remove the fuel fill pipe (A)
- Install the parts in the reverse order of removal
NOTE:
Before connecting the fuel fill pipe and the quick-connect fitting, check for dirt, and clean it if needed, taking care not to damage the fuel fill pipe and other parts
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.