Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Enable Conditions
ENABLE CONDITIONS CHART
| Condition | Minimum | Maximum | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Elapsed time after monitor finishing condition except immediate starting the engine | 1 seconds | - | |||||||||
| Engine coolant temperature | 68°F (20°C)(1) | - | |||||||||
| Engine speed | 500 rpm | 6,800 rpm(3) 6,700 rpm(4) |
|||||||||
| MAP value(2) | 750 rpm(3) | 25 kPa (7.3 in.Hg, 184 mmHg) | - | ||||||||
| 650 rpm(4) | 25 kPa (7.3 in.Hg, 185 mmHg) | - | |||||||||
| 2,000 rpm | 20 kPa (5.9 in.Hg, 149 mmHg)(3) 18 kPa (5.4 in.Hg, 135 mmHg)(4) |
- | |||||||||
| Fuel feedback | Other than during fuel cut-off operation | ||||||||||
| No active DTCs | P0107, P0108, P0117, P0118, P0122, P0123, P0222, P0223, P0335, P0339, P1128, P1129, P2227, P2228, P2229 | ||||||||||
| Other | Test-drive on a flat road to avoid misdetection | ||||||||||
|
|||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.