Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Acura TL BaseFACTORY OEM SERVICE PROCEDURE
Enable Conditions
ENABLE CONDITIONS CHART
| Condition | Minimum | Maximum | ||
|---|---|---|---|---|
| Elapsed time after engine start | 10 seconds | - | ||
| Fuel feedback | Other than during fuel cut-off operation | |||
| No active DTCs | P0101, P0102, P0103, P0107, P0108, P0117, P0118, P0134, P0135, P0154, P0155, P0171, P0172, P0174, P0175, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0335, P0339, P0351, P0352, P0353, P0354, P0355, P0356, P0401, P0404, P0443, P0496, P0497, P0506, P0507, P0627(1), P1077, P1078, P1128, P1129, P1172, P1174, P145C, P2195, P2197, P2227, P2228, P2229, P2237, P2238, P2240, P2241, P2243, P2245, P2247, P2249, P2251, P2252, P2254, P2255, P2279, P2413, P2610, P2646, P2647, P2648, P2649 | |||
| Others | With a completely cooled engine (one that has been off for at least 6 hours): Judgment is made after the engine has run for at least 30 minutes or been driven at least 4 miles (5 km), turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode for at least 10 seconds, then started and run again for at least 10 seconds. | |||
| With a partially cooled engine (one that has been off for less than 6 hours): Judgment is made after the engine has run for at least 30 minutes or been driven at least 4 miles (5 km), turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode for at least 3 hours, then started and run again for at least 10 seconds. | ||||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.