2011 Acura RLFACTORY OEM SERVICE PROCEDURE

Transfer Assembly Removal

  1. Raise the vehicle on a lift, and make sure it is supported securely.
  2. Shift the transmission into N.
  3. Remove the splash shield (see SPLASH SHIELD REPLACEMENT ).
  4. Remove the drain plug (A) and the sealing washer (B), and drain the automatic transmission fluid (ATF).
    Fig 1: Removing Drain Plug And Sealing Washer With Torque Specifications
    G07362745Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Reinstall the drain plug with a new sealing washer.
  6. Remove exhaust pipe A.
    Fig 2: Removing Exhaust Pipe
    G07362746Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the bolt securing the transfer breather hose bracket (A), and disconnect the breather hose (B) from the breather pipe (C) on the transfer assembly.
    Fig 3: Disconnecting Breather Hose From Breather Pipe On Transfer Assembly
    G07362747Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Make reference marks (A) across the propeller shaft (B) and the transfer companion flange (C).
    Fig 4: Identifying Reference Marks For Propeller Shaft And Transfer Companion Flange
    G07362748Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Separate the propeller shaft from the transfer companion flange.
  10. Remove the transfer assembly from the transmission.
    Fig 5: Removing Transfer Assembly From Transmission
    G07362749Courtesy of AMERICAN HONDA MOTOR CO., INC.
Chapter Navigation
Return to Chapter: Transfer Assembly
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.