Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Acura ZDXFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| Auxiliary Under-Dash Fuse Holder | Left kick panel. See Figure. |
| Auxiliary Under-Hood Fuse/Relay Box | Left side of engine compartment. See Figure. |
| Back-Up Sensor In-Line Fuse | Right rear of cargo area. See Figure. |
| Junction Box (Driver's) | Left side of dash. See Figure. |
| Junction Box 1 & 2 (Passenger's) | Right side of dash. See Figure. |
| Keyless Access Junction Box | Left end of dash. See Figure. |
| Under-Dash Fuse/Relay Box (Driver's) | Left side of dash. See Figure. |
| Under-Dash Fuse/Relay Box (Passenger's) | Right kick panel. See Figure. |
| Under-Hood Fuse/Relay Box | Right side of engine compartment. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.