Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Acura TSX StandardFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal Module Removal and Installation: Removal
- Disconnect the accelerator pedal module connector (A)
- Remove the clip (B)
- Using flat-tip screwdriver (C), push the lock (D), then remove the accelerator pedal module (E)NOTE:
- The APP sensor is not available separately Do not disassemble the accelerator pedal module
- If the pedal stop (F) is damaged, pull back the carpet, remove the nuts (G) and bolt (H), and replace the pedal stop
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
