2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE

Navigation cannot control audio/disc

WARNING: This page is about a different car, the 2008 Acura CSX, 2007 Acura CSX, and 2006 Acura CSX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the anti-theft code for the navigation system is entered.
  2. Go into the Diagnostic Menu and use the "Navi System Link" test (see SYSTEM DIAGNOSTIC MODE  ).

    Is the "Radio" icon red? 

    YES  -Do the TROUBLESHOOTING FOR THE VOICE GUIDANCE CANNOT BE HEARD  .

    NO  -Go to step 3.

  3. Substitute a known-good navigation unit (see NAVIGATION UNIT REMOVAL/INSTALLATION  ), and recheck.

    Can the navigation control audio? 

    YES  -Replace the navigation unit (see NAVIGATION UNIT REMOVAL/INSTALLATION  ).

    NO  Do the audio system troubleshooting.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.