Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Entering Security Code
Any time the navigation system loses power, you need to enter the 4-digit anti-theft code on the navigation system display. The 4-digit code is located on a small card that was given to the customer. Enter the 4-digit code, then select Done.
If the navigation system anti-theft code is missing, use the interactive Network (iN) to look it up. You will need the serial number for the navigation unit to do this. You can view the serial number by entering the diagnostic mode. Select Unit Check from the main menu, then the Navi ECU diagnostic screen. This gives you the serial number without removing the navigation unit.
The iN may display more than one code for a given serial number. This is because serial numbers are not unique. You may have to try more than one 4-digit code. If no code is shown, or if the code(s) given do not work in the navigation unit, contact the AutomobileWarranty department. If the code 0000 works, replace the navigation unit.
When replacing the navigation unit, make sure you give the customer the new anti-theft security code.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.