2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE

Ignition Key Switch Test

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column upper and lower covers (see STEERING COLUMN COVER REMOVAL/INSTALLATION )
  2. Disconnect the 6P connector (A)
    Fig 1: Identifying 6P Connector
    G05988990Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between terminals No l and No 2
    • There should be continuity with the key in the ignition switch
    • There should be no continuity with the key removed
  4. If the continuity is not as specified, replace the steering lock assembly (see STEERING LOCK REPLACEMENT )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.