2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE

Combination Light Switch

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

The driver's MICU control of the lighting system is based on input signals from the combination light switch

INPUT AND OUTPUT CHART

Β  Input Output
Driver's MICU Combination light switch (OFF)
Combination light switch (ON)
Combination light switch (AUTO)
Combination light switch (PARKING)
Combination light switch (PASSING)
Combination light switch (DIMMER)
Parking light
Headlight (high beam, low beam, passing)
Taillights
Headlight (AUTO)
B-CAN Β  Parking light
Headlight (high beam, low beam, passing)
Taillights
Headlight (AUTO)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.