Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE
Interface Dial Inputs and Outputs
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
INTERFACE DIAL 5P CONNECTOR TERMINAL REFERENCE
| Terminal Number | Wire Color | Terminal Name | Description | Voltage (about) | Symptom | ||
|---|---|---|---|---|---|---|---|
| 1 | BLU | JOG (jog) | Interface dial operation signal | 0-5 V pulses | If open You can not operate the navigation system If short to ground You can not operate the navigation system | ||
| 2 | GRY(1) | JOG SH (Shield jog) | Shield for interface dial signal | -- | -- | ||
| 3 | BLK | GND (Ground) | Ground for interface dial | 0V | If open You can not operate the navigation system If short to ground You can not operate the navigation system |
||
| 4 | PUR | ACC (Accessory) | Power source for interface dial | Battery voltage at ACC mode | If open You can not operate the navigation system If short to ground Blows fuse No 18 (7 5 A) in the driver's under-dash fuse/relay box |
||
The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram |
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
