Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test System Links
- Check the vehicle battery condition first (see BATTERY TEST )
- Check for and resolve all CAN DTCs before troubleshooting the navigation system
- Verify that the correct navigation unit is installed for this model Go into the Diagnostic mode, and use Version (see VERSION )
- Check the connectors for poor connections or loose terminals
- Before troubleshooting, make sure you have the anti-theft code
- After troubleshooting, enter the anti-theft code
- Check any official Honda service website for more service information about the navigation system
- Connect the HDS to the DLC
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Check for DTCs with the HDS
Are there any DTCs present?
YES -Troubleshoot the DTC, then retest
NO -Go to step 4
- Make sure the anti-theft code is entered
- Go into the System Diagnostic mode, and use the use the System Links diagnosis (see
SYSTEM DIAGNOSTIC MODE )
Is the Radio icon red?
YES -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION )
NO -Go to step 6
- Substitute a known-good HDD (see HDD Removal/Installation ), and recheck
Can the navigation system control audio/disc functions?
YES -Replace the HDD
NO -Do the audio system troubleshooting
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
