Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE
Navigation Display Unit Removal/Installation
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Put on gloves to protect your hands
- Take care not to scratch the dashboard and related parts
- Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage
- When prying components, use the handy remover set or equivalent
- Remove the dashboard center vent (see DASHBOARD CENTER VENT REMOVAL/INSTALLATION )
- Remove the screws and bolt from the navigation display unit (A)
Bolt specifications: 5 x 0.8 mm, 4.4 N.m (0.45 kgf m, 3.2 lbf ft)
- Pull out the navigation display unit Then disconnect the connector (A) from the navigation display unit
- Install the navigation display unit in the reverse order of removal
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.