Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE
Forced Starting of Display: Notes
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
SCS service connector 07PAZ-0010100
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
- Remove the right side kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS )
- Connect the SCS service connector (A) to the navigation service connector (B) located by the passenger's kick panel
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menuNOTE: If the display fails to display the system link screen, refer to no picture is displayed (see No picture is displayed )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.