Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE
Evaporator Temperature Sensor Test
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before testing the sensor, check for HVAC DTCs (see
GENERAL TROUBLESHOOTING INFORMATION )
- Remove the evaporator temperature sensor (see Evaporator Temperature Sensor Replacement )
- Dip the sensor in ice water, and measure the resistance between its terminals No. 1 and 2.
- Pour warm water on the sensor, and measure the resistance
- Compare the resistance readings with the specifications shown in the graph, the resistance should be within the specifications
- If the resistance is not as specified, replace the evaporator temperature sensor (see Evaporator Temperature Sensor Replacement )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.