Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U0155: Climate Control Unit Lost Communication with Gauge Control Module
- Clear the DTC with the HDS
- Turn the ignition switch to LOCK (0), and then back to ON (II), or press the engine start/stop button to select the OFF mode, and then the ON mode
- Do the self-diagnostic function with the HDS (see HOW TO USE THE SELF-DIAGNOSTIC FUNCTION WITH THE HDS )
- Check for DTCs
Is DTC U0155 indicated?
YES -Go to step 5
NO -The system is OK at this time Check for loose wires or poor connections on the B-CAN lines between the gauge control module and the climate control unit
- Select UNIT INFORMATION in the BODY ELECTRICAL menu
- Select CONNECTED UNIT in the UNIT INFORMATION menu
Is the gauge control module detected?
YES -Substitute a known-good climate control unit, and recheck If the symptom/indication goes away, replace the original climate control unit (see CLIMATE CONTROL UNIT REMOVAL/INSTALLATION )
NO -Go to step 7
- Disconnect the gauge control module 32P connector
- Disconnect climate control unit connector C (20P)
- Check for continuity between the following terminals of the gauge control module 32P connector and climate control unit connector C (20P)
20P 32P
No 7 No 25
No 8 No 26
Fig 1: Checking Continuity Between Terminals Of Gauge Control Module 32P Connector And Climate Control Unit Connector C (20P)Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Go to the gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST )
NO -Repair open in the wire(s) between the climate control unit and the gauge control module
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
