2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE

Wheel Sensor Replacement: Rear

  1. Turn the ignition switch to LOCK (0).
  2. Release the clamp (A), then disconnect the wheel speed sensor connector (B).
    Fig 1: Clamp, Wheel Speed Sensor Connector And Wheel Speed Sensor With Torque Specifications
    G06274617Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the clips, the bolt, and the wheel speed sensor (C).
  4. Apply multi-purpose grease to the wheel speed sensor O-ring (A) and the sensor hole in the knuckle (B).
    Fig 2: Applying Multi-Purpose Grease To Wheel Speed Sensor O-Ring
    G06274618Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Insert the guide pin tool (A) into the wheel speed sensor bolt hole until the shoulder of the tool contacts the wheel speed sensor bracket.
    NOTE: To prevent O-ring damage, the wheel speed sensor must be installed with the guide pin tool.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.