2009 Acura CSX Base, StandardFACTORY OEM SERVICE PROCEDURE

Standards and Service Limits: Suspension

SUSPENSION SPECIFICATION

Item Measurement Qualification Standard or New Service Limit
Wheel alignment Camber Front 0°00'±45'
Rear (without "C" marks on the rear upper arm) -1 °30' +1.08-0.45
Rear (with "C" marks on the rear upper arm) -1 °45' +1.08-0.45
Caster Front 7°00'
Total toe-in Front 0±2 mm (0±0.08 in.)
Rear 2+2-1 mm (0.08+0.08-0.04 .in.)
Front wheel turning angle Inward 38°46'±2°
Outward 31 ° 14 '(Reference)
Aluminum wheel Runout Axial 0-0.7 mm (0-0.03 in.) 2.0 mm (0.08 in.)
Radial 0-0.7 mm (0-0.03 in.) 1.5 mm (0.06 in.)
Wheel bearing End play Front 0-0.05 mm (0-0.002 in.)
Rear 0-0.05 mm (0-0.002 in.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.