2009 Acura CSX Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Regulator Replacement

  1. Remove the fuel tank unit (see FUEL TANK UNIT REMOVAL/INSTALLATIONΒ  ).
  2. Remove the bracket (A).
    Fig 1: Identifying Fuel Pressure Regulator And Bracket With Ground Ring
    G06264749Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the ground ring (B).
  4. Remove the fuel pressure regulator (C).
  5. Install the parts in the reverse order of removal with new O-rings (D) and a new bracket (A). When installing the fuel tank unit, align the marks on the unit and the fuel tank (see FUEL TANK UNIT REMOVAL/INSTALLATIONΒ  ).
    NOTE: Coat the O-rings with clean engine oil; do not use any other oil. Do not pinch the O-rings during installation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.