Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMADVANCED DIAGNOSTICSDTC P0706: OPEN IN TRANSMISSION RANGE SWITCH CIRCUITDRIVING PATTERN
2008 Acura TSX Standard
Driving Pattern
2008 Acura TSX StandardSECTION Driving Pattern
- Start the engine, and accelerate to 30 mph (48 km/h) or more in D position, then slow down to 6 mph (10 km/h).
- Stop the vehicle, turn the ignition switch OFF, and repeat step 1.
- Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.