Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX STANDARDREPAIR AND DIAGNOSISBODY & FRAMESEATSDRIVER POSITION MEMORY SYSTEM (DPMS)POWER SEAT ADJUSTMENT SWITCH TEST/REPLACEMENT
2008 Acura TSX Standard
Power Seat Adjustment Switch Test/Replacement
2008 Acura TSX StandardSECTION Power Seat Adjustment Switch Test/Replacement
- Remove the power seat adjustment switch knobs (A) and recline cover from the driver's power seat (see FRONT SEAT DISASSEMBLY/REASSEMBLY - DRIVER'S 8-WAY POWER ), then remove the two screws and the power seat adjustment switch.
- Disconnect the 12P connector from the power seat adjustment switch (B).
- Reinstall the adjustment switch knobs to the switch.
- Check for continuity between the terminals in each switch position according to Fig 2.
- If the continuity is not as specified, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.