Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMPGM-FI SYSTEMCMP SENSOR B REPLACEMENT
2008 Acura TSX Automatic
CMP Sensor B Replacement
2008 Acura TSX AutomaticSECTION CMP Sensor B Replacement
- Remove the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
- Remove the EVAP canister purge valve (see EVAP CANISTER REPLACEMENT ).
- Disconnect the CMP sensor B 3P connector (A).
- Remove CMP sensor B(B).
- Install the parts in the reverse order of removal with a new O-ring (C).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.