SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSIDLE CONTROL SYSTEMIDLE SPEED INSPECTION
2008 Acura TSX Automatic

Idle Speed Inspection

2008 Acura TSX AutomaticSECTION Idle Speed Inspection
NOTE:
  • Before checking the idle speed, check these items: -The malfunction indicator lamp (MIL) has not been reported on.
    • Ignition timing - Sparkplugs - Air cleaner
    • PCV system
  • Apply the parking brake, and make sure the headlights are off.
  1. Disconnect the evaporative emission (EVAP) canister purge valve connector.
  2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
    Fig 1: Identifying Data Link Connector
    G05490758Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch ON (II).
  4. Make sure the HDS communicates with the ECM/PCM. If it doesn't go to the DLC circuit troubleshooting; '04-06 models (see '04-06 MODELS ), '07-08 models (see '07-08 MODELS ).
  5. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle.
  6. Check the idle speed without load conditions: headlights, blower fan, radiator fan, and air conditioner off.

    Idle speed should be: 

    '04-05 models 

    IDLE SPEED REFERENCE - 04-05 MODELS

    M/T 750 ± 50 rpm
    A/T 800 ± 50 rpm (in Park or neutral)

    '06-08 models 

    IDLE SPEED REFERENCE - 06-08 MODELS

    M/T 780 ± 50 rpm
    A/T 800 ± 50 rpm (in Park or neutral)
  7. Let the engine idle for 1 minute with high electric load (A/C switch on, temperature set to max cool, blower fan on High, rear window defogger on, and headlights on high beam).

    Idle speed should be: 

    '04-05 models 

    IDLE SPEED REFERENCE - 04-05 MODELS

    M/T 750 ± 50 rpm
    A/T 800 ± 50 rpm (in Park or neutral)

    '06-08 models 

    IDLE SPEED REFERENCE - 06-08 MODELS

    M/T 780 ± 50 rpm
    A/T 800 ± 50 rpm (in Park or neutral)
    NOTE: If the idle speed is not within specification, do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE  ). If the idle is still not within specification, go to the symptom troubleshooting.
  8. Reconnect the EVAP canister purge valve connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.