2008 Acura TL V6-3.2LFACTORY OEM SERVICE PROCEDURE

Wiper/Washer Switch Test/Replacement

Wiper/Washer Switch Test/Replacement

NOTE: The wiper/washer switch is built into the combination switch control unit. For the wiper/washer test, refer to the combination switch control unit input test. Combination Switch Control Unit Input Test

1. Remove the dashboard lower cover.
2. Remove the steering column covers.
3. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B), and the combination light switch 12P connector (C).

Factory service manual diagram





4. Remove the two screws, then slide out the wiper/washer switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.