Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
APP Sensor Replacement
2008 Acura TL V6-3.2LSECTION APP Sensor Replacement
APP Sensor Replacement
1. Remove the throttle cable.
2. Disconnect the accelerator pedal position (APP) sensor 6P connector (A).
3. Remove the bolts (B), and the APP sensor (C).
4. Install the parts in the reverse order of removal.
1. Remove the throttle cable.
2. Disconnect the accelerator pedal position (APP) sensor 6P connector (A).
3. Remove the bolts (B), and the APP sensor (C).
4. Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.