Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Acura TL V6-3.2LFACTORY OEM SERVICE PROCEDURE
Climate Control Switch Assembly Removal/Installation
Climate Control Switch Assembly Removal/Installation
1. Remove the audio-HVAC display module assembly.
2. Remove the self-tapping screws and the audio unit (A) and bracket (B) from the display panel control unit (C).
3. Disconnect 10P connector (A) and 16P connector (B) from the display panel control unit (C). Remove the self-tapping screws and the climate control switch assemblies (D).
4. Install the control switch assembly in the reverse order of removal. After installation, operate the control switch assembly controls to see if they work properly.
5. Run the self-diagnostic function to confirm that there are no problems in the system.
1. Remove the audio-HVAC display module assembly.
2. Remove the self-tapping screws and the audio unit (A) and bracket (B) from the display panel control unit (C).
3. Disconnect 10P connector (A) and 16P connector (B) from the display panel control unit (C). Remove the self-tapping screws and the climate control switch assemblies (D).
4. Install the control switch assembly in the reverse order of removal. After installation, operate the control switch assembly controls to see if they work properly.
5. Run the self-diagnostic function to confirm that there are no problems in the system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.