Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Acura TL V6-3.2LFACTORY OEM SERVICE PROCEDURE
Audio-HVAC Display Module Assembly Removal/Installation
Audio-HVAC Display Module Assembly Removal/Installation
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before performing repairs or service.
NOTE:
- Eject all the discs before removing the audio unit to prevent damaging the CD/DVD player's load mechanism.
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
1. Make sure you have the anti-theft codes for the audio system.
2. Remove the center console trim and center console panel.
3. Remove the dashboard center vent.
4. Remove the bolts, then pull out the audio-HVAC display module assembly (A).
5. Disconnect the connectors (B, C), then remove the audio-HVAC display module assembly.
6. Install the audio-HVAC display module assembly in the reverse order of removal, and note these items:
- Make sure all connectors and AM/FM antenna sublead are secure.
- Enter the anti-theft codes for the audio system.
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before performing repairs or service.
NOTE:
- Eject all the discs before removing the audio unit to prevent damaging the CD/DVD player's load mechanism.
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
1. Make sure you have the anti-theft codes for the audio system.
2. Remove the center console trim and center console panel.
3. Remove the dashboard center vent.
4. Remove the bolts, then pull out the audio-HVAC display module assembly (A).
5. Disconnect the connectors (B, C), then remove the audio-HVAC display module assembly.
6. Install the audio-HVAC display module assembly in the reverse order of removal, and note these items:
- Make sure all connectors and AM/FM antenna sublead are secure.
- Enter the anti-theft codes for the audio system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.