Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TL V6-3.2LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING SWITCHSERVICE AND REPAIR
2008 Acura TL V6-3.2L
Memory Positioning Switch: Service and Repair
2008 Acura TL V6-3.2LSECTION Service and Repair
Driving Position Memory Switch Test/Replacement
1. Remove the driver's door panel.
2. Disconnect the 10P connector from the memory switch (A).
3. Check for continuity between the terminals in each switch position according to the table.
4. If the continuity check is not as specified, replace the bulbs (B), or remove the screws and replace the switch.
1. Remove the driver's door panel.
2. Disconnect the 10P connector from the memory switch (A).
3. Check for continuity between the terminals in each switch position according to the table.
4. If the continuity check is not as specified, replace the bulbs (B), or remove the screws and replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.