Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA2008RLREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSELECTRONIC THROTTLE CONTROL SYSTEMACCELERATOR PEDAL MODULE REMOVAL/INSTALLATION

2008 Acura RL

Accelerator Pedal Module Removal/Installation

2008 Acura RLSECTION Accelerator Pedal Module Removal/Installation

Disconnect the APP sensor connector (A).

Fig 1: APP Sensor Connector With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Release the lock tab on the base of the accelerator pedal, then remove the accelerator pedal module (B).
Install the parts in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.