Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008RL V6-3.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSACCELERATOR PEDAL POSITION SENSORSERVICE AND REPAIR
2008 Acura RL V6-3.5L
Accelerator Pedal Position Sensor: Service and Repair
2008 Acura RL V6-3.5LSECTION Service and Repair
Accelerator Pedal Module Removal/Installation
1. Disconnect the APP sensor connector (A).
2. Release the lock tab on the base of the accelerator pedal, then remove the accelerator pedal module (B).
3. Install the parts in the reverse order of removal.
1. Disconnect the APP sensor connector (A).
2. Release the lock tab on the base of the accelerator pedal, then remove the accelerator pedal module (B).
3. Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.