Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008MDXREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONATF REPLACEMENT
2008 Acura MDX
ATF Replacement
2008 Acura MDXSECTION ATF Replacement
NOTE:
Keep all foreign particles out of the transmission.
- Park the vehicle on the level ground.
- Warm up the engine to normal operating temperature (the radiator fan comes on), and turn the engine off.
- Raise the vehicle up on a lift, apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
- Remove the transmission undercover.
- Remove the ATF filler bolt and drain plug (A), and drain the automatic transmission fluid (ATF).NOTE: If a cooler cleaning is done, refer to ATF cooler cleaning (see ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.