Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Enable Conditions
2008 Acura MDXSECTION Enable Conditions
ENABLE CONDITIONS CHART
| Condition | Minimum | Maximum | ||||
|---|---|---|---|---|---|---|
| Battery voltage | 11.0 V | - | ||||
| Engine coolant temperature | 158°F (70°C) | - | ||||
| ATF temperature | - | -4°F (-20°C)(1) | ||||
| 230°F (110°C)(2) | - | |||||
| Vehicle speed | 19 mph (30 km/h)(1) | - | ||||
| Throttle position | 4.0 °(1) | - | ||||
| Initial engine coolant temperature | - | 95°F (35°C)(1) | ||||
| Previous engine coolant temperature when the ignition switch was turned OFF | 158°F (70°C)(2) | - | ||||
| Present engine coolant temperature when the ignition switch is turned ON | - | 95°F (35°C)(2) | ||||
| No active DTCs | P0116, P0117, P0118, P0712, P0713, P0721, P0722 | |||||
| Other | After the engine coolant temperature reaches the fixed value, both the vehicle speed and the throttle position meet the conditions for at least 5 minutes(1) | |||||
|
||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.