Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008MDXREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOWSREAR POWER WINDOW SWITCH TEST/REPLACEMENT
2008 Acura MDX
Rear Power Window Switch Test/Replacement
2008 Acura MDXSECTION Rear Power Window Switch Test/Replacement
- Remove the rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ), and disconnect the 14P connector from the rear power window switch.
- Remove the power window switch panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).
- Remove the three mounting screws and the rear power window switch (A).
- Swap the rear power window switch with another known-good power window switch and test. If the original power window switch is faulty; replace it.
- Install the switch in the reverse order of removal.
- Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.